
A horn cleat has two horns on a base. You wrap a dock line under one horn, over the other, and finish with a locking turn. The base bolts through a deck or a dock.
Profab Machine makes each stainless steel horn cleat to your drawing or sample. You set the length, the base, and the bolt holes. Choose 304 or 316 stainless steel to suit the water.
Common horn cleat lengths run from 4 in to 12 in. The table below lists typical sizes, and we match your drawing where it differs.
Applications: Boat decks, docks, pontoons, and commercial workboats.
Typical sizes from two cleat makers. Hole spacing is measured center to center. Makers differ by up to about 1/16 in, so the 6, 8, and 10 in rows are the middle of both makers. The 4 and 5 in rows come from one maker and the 12 in row from the other. Height and thickness differ more between makers. Give them on your drawing.
| Cleat Length | Hole Spacing | Base Width | Fastener Hole |
|---|---|---|---|
| 4 in (102 mm) | 1-3/4 in | 1 in | #10 |
| 5 in (127 mm) | 2-1/8 in | 1 in | #10 |
| 6 in (152 mm) | 2-1/4 in | 1-1/16 in | 1/4 in |
| 8 in (203 mm) | 2-13/16 in | 1-3/8 in | 1/4 in |
| 10 in (254 mm) | 3-5/8 in | 1-3/4 in | 5/16 in |
| 12 in (305 mm) | 3-15/16 in | 1-15/16 in | 5/16 in |
Send a drawing, a DXF file, or a sample. Our engineers review the dimensions and the tolerance before cutting metal. We CNC machine the part ourselves, so you deal directly with the factory.
You set the cleat length, the horn shape, the base footprint, and the bolt hole size. We CNC machine the parts to that drawing. The cleat then fits your deck or your dock.
316 resists salt best, so it suits seawater, docks, and marinas. 304 suits fresh water and dry use. We confirm the grade against your drawing.












A horn cleat is a fitting with two horns on a base. A dock line wraps around the horns in a figure-eight and finishes with a locking turn.
Choose a length that holds a full figure-eight and a locking turn on your line. A thicker line needs a longer cleat. Send the line diameter and we confirm the length.
Yes. Send your hole pattern and the base outline, or send a sample. We machine the base to that pattern.
Most horn cleats bolt through the deck or the dock. Typical holes are 1/4 in on 6 and 8 in cleats and 5/16 in on 10 and 12 in cleats. A backing plate under the deck spreads the load.
Choose 316 where the cleat sees salt water, salt spray, or chloride-based cleaning chemicals. Choose 304 for fresh water or dry use.
Send the cleat length, the base size, and the bolt hole pattern. Add the line diameter, the grade, the finish, and the quantity. A drawing or a sample speeds up the quote.
If you already have drawings, email them to [email protected].
[email protected] ↗We use cookies to run this site, to measure how it is used, and to show relevant ads. You can accept all, reject all non-essential cookies, or choose by category. Privacy Policy